HONDA GL18000 DRIVER BOARDS REPLACEMENT RUBBER PADS INSTALLATION INSTRUCTIONS
download 1. Remove any loose pads, remove any remaining rubber & glue using a blade screwdriver or razor blade. 2. Rough up the chrome surface with sand paper or by scratching with the tip of a...
View ArticleStreet Magic Magical Wizards LED Installation Instructions
download 1. Always wear appropriate safety gear including safety glasses when soldering or performing any electrical work. It is highly recommended that safety glasses be worn throughout this...
View ArticleHARLEY DAVIDSON FLST REPLACEMENT WINDSHIELD KITS INSTALLATION INSTRUCTIONS
download INSTALLATION 1. See Figure 1. Remove stock windshield. 2. Remove all hardware that secures mounting brackets to windshield. The nine screws must be removed with a T- 27 TORX® screwdriver. Save...
View ArticleDETACHABLE KING SIZE WINDSHIELD FOR SOFTAIL MODELS WITH CHROME HEADLAMP...
download Installation 1. Remove upper screws that attach the chrome headlamp nacelle to the front forks. 2. See Service Parts illustration. Attach the upper docking bushings (22) using washer (21) and...
View Article1996-2004 HONDA XR250R Removing stock carburetor and cables
download Install the throttle cables into the supplied throttle housing and place onto clean handlebar end. 2. Remove the rubber carburetor alignment tabs from the manifold using a razor blade or sharp...
View ArticleHonda TRX 400EX INSTALLATION And REMOVAL INSTRUCTIONS
download Quiet cores are supplied with this kit but not installed. To install the quiet cores remove both rear end caps ((turn downs) and install the quiet cores with the tubes facing inward....
View ArticleHONDA TRX 400EX Removing Stock Carb and Cables INSTRUCTION
download Remove seat/fender assembly and fuel tank. 2. Remove throttle cables paying close attention to routing. 3. Remove thumb throttle housing if you are installing a twist throttle. 4. Remove air...
View ArticleHarley Davidson Motorcycles Hot Grips Installation Manuals
download End weights or other need to open the ends: You may drill out the outboard ends of the grips for installation of end weights or other purpose, if you use a fine tooth hole saw and do not go...
View ArticleKawasaki ZX-14 Installation And Removal Manual
download 1) Tools needed: 36mm socket / 32mm socket / 5mm Allen wrench / cordless drill / tap handle / hammer / razor blade. 2) The frame bracket serves as the drilling guide and we provide the...
View Article
More Pages to Explore .....